General manager:Mr.mu 
    +86 13906466029  
Sales Department
    +86 0536-6711131
Weifang Changsheng Nitrate Co., Ltd.
Fax:0536-6712131
E-mail:changshengxiaoyan@163.com 
Website:www.wfcsxygs.com
ADD:Zhuliu Industrial Park,changle county, Shandong Province.
Zip code:262404
PRODUCTS
POSITION:HOME>PRODUCTS

Thermal Energy Storage Molten Salt


Molten salts (including heat-conducting salts and thermal media) are inorganic salts melted into a heat-transfer medium. They are molten bodies composed of metal cations and non-metal anions. At standard temperature and atmospheric pressure they are solid; when heated, they become liquid salts.
1. Product Name:Energy storage molten salt

Item
melting point
boiling point
Heat of Fusion
Specific Heat
Average Thermal Conductivity
Operating Temperature
Appearance
Specification
142℃-148℃
680℃
18Kcal/Kg
0.34 kcal/Kg·℃
0.317
150℃-550℃
Pale-yellow crystals or granules

2. Instructions for Use
Put the thermally conductive molten salt into the tank and heat it directly to melt it, or add a small amount of water to the thermally conductive molten salt and heat it to melt it. After melting to a sufficient viscosity, it can be circulated with a circulation pump, and then sent to a heat-carrying furnace to gradually increase the temperature in a cycle to reach the target temperature.
3. Things to note
① Molten salt should be kept clean and should not come into contact with organic matter such as carbon, rosin or reducing substances to avoid causing violent chemical reactions. 
② When starting to heat up, strictly control the heating rate and try to avoid rapid cooling and heating during system operation. 
③ The flow rate is constant during circulating heating and cannot exceed the film temperature. 
④ When using at high temperatures, it is strictly forbidden to mix water and organic substances. 
⑤ When the temperature of commonly used molten salt exceeds 550℃, the molten salt becomes unstable, reacts, releases gas, and the melting point of the molten salt increases, causing the molten salt to deteriorate. 
⑥ When there is a lot of sediment in the molten salt of the heat carrier, the molten salt should be replaced.
⑦ Before stopping, all the molten salt must be poured back into the molten salt storage tank, and then the shutdown procedure can be entered.

Thermal Energy Storage Molten Salt 本文被阅读 23571 次
NEXT:Low-melting-point Molten SaltPREVIOUS:Calcium Nitrate
ADD:Zhuliu Industrial Park,changle county, Shandong Province. Phone:+86 0536-6711131 Fax: 0536-6712131  E-mail:changshengxiaoyan@163.com 
Weifang Changsheng Nitrate Co., Lt www.wfcsxygs.com LU ICP备10206863号 Copyright | Technical support:shandongguguo